EZ-Slide is also available in a dry graphite powder, packaged in one-pound and five- pound containers. EZ-Slide Talc Powder is also available, for vacuum planters and is packaged in eight-pound containers.
EZ-Slide can be used on farm and industrial equipment, gravity boxes, corn picker heads, combines, truck and wagon beds, buckets, blades, garage door tracks, snow blowers, lawn and garden tools, saw blades, dump bins, solar panel coating, snow plow blades, and more!
EZ-Slide can also be used under lawn mower decks. EZ-Slide will create a smooth surface that will prevent lawn discharge from sticking to the underneath of your mower deck.
APPLICATION TIPS
EZ-Slide is also available in a dry graphite powder, packaged in one-pound and five- pound containers. EZ-Slide Talc Powder is also available, for vacuum planters and is packaged in eight-pound containers.
EZ-Slide can be used on farm and industrial equipment, gravity boxes, corn picker heads, combines, truck and wagon beds, buckets, blades, garage door tracks, snow blowers, lawn and garden tools, saw blades, dump bins, solar panel coating, snow plow blades, and more!
EZ-Slide can also be used under lawn mower decks. EZ-Slide will create a smooth surface that will prevent lawn discharge from sticking to the underneath of your mower deck.
EZ-Slide is black graphite coating designed for any farm, home or industrial applications where a smooth, low-friction coating is needed. EZ-Slide bonds quickly to any clean metal, wood, concrete and most plastic surfaces. Available in two different formulas, EZ-Slide can be applied with a brush or spray can. RB-9512 is the oil-based formula, available in gallons, quarts, and aerosol spray cans. QB-9511 is the waterborne formula, available in gallon containers.The surface to be painted must be clean and dry. Remove all dirt, grease, or loose, scaling paint by wire brushing, scraping or sanding. Sand all glossy surfaces with sandpaper for better adhesion. Any rusty metal should be cleaned, and the rust that is present removed. Clean new metal surfaces with a mineral spirit soaked rag. Places the peel off are due only to improper surface preparation. Do not use oil or grease after applying EZ-Slide, as this will tend to loosen the bond.
If THINNING is necessary, use a small amount of paint thinner.
Mix well, apply with a clean brush or apply with a spray can. Allow to dry for at least 60 minutes at 70º F, before applying a second coat to insure a good film base. The SPREADING RATE will be approximately 300-400 square feet per gallon, depending on the type of surface to which it is applied. This paint also conducts heat and electricity, and is unaffected by temperature changes when dry (from -75ºF, to approximately 600ºF).
CLEAN-UP your brush and painting equipment with paint thinner. DRYING TIME will be about 60 minutes at 70ºF, until recoat, and overnight dry before you may use it.
